Secrets to ensure the life of your powder nail polish

Transcript of the video

Here are some tips on how to extend the life of your manicure.

Always remember not to wash or wet your hands before the treatment and also not to apply oils or creams because this could definitely compromise its duration.

Push the cuticles well before starting the treatment using the special tool that you will find inside your kit.

This will help you spread both the base and the color much better in the cuticle area so as to be able to obtain a much more precise final result.

Using this part of the file, always remember to matt the entire surface of your nails well. This will ensure greater adhesion of the product to the foil.

To avoid a dense or uneven result, unload the brush well and then apply a super thin base without touching or dripping the product into the cuticles because this could cause lifting and therefore compromise the duration of the treatment.

This applies to both the base and the color. By paying close attention to this small but fundamental detail, I can assure you that the final result will be exactly like this.

Another super important thing to remember, unlike the base, the activator must be applied in a generous quantity so that it is smeared over the entire surface of the nail and remember also and above all at the tip you must seal the tip well with the activator.

I hope these tips were useful to you, let us know with a like and a comment on the next video.


Our Advice

✔️Do not use hand/nail care lotions before application, as the greasy surface reduces adhesion.

✔️ Make sure you only apply essential liquids to one nail at a time and immediately dip the nail into the powder before moving on to the next finger.

✔️ Apply only a thin layer of liquid at a time to avoid unwanted deformations or thickening.

✔️ Gently brush off excess powder after each use.

✔️ Take your time between individual steps to get the best possible result.

✔️ Respect the waiting times specified between Activator - Top Coat.

✔️ Apply a sufficient amount of Activator so that the powder adheres optimally and no air bubbles form at the edges. Don't forget the tip and edges of the nail.

✔️ Always wait until you have completed the entire coat before removing excesses with the brush.

✔️ Close liquids immediately after use, to avoid the product solidifying.

✔️ Clean the applicators after each manicure, immersing them in the brush saver for approximately 15-20 minutes.